Edit 7/13: After printing the top part of the helmet, I found some areas that were thin and knew would cause trouble, went back in and thickened it back up. Edited the placement of the bevels to match the ingame model better, better alignment on the tentacle pieces on the inside for welding, re-rendered, and split the mask into two due to how tall it is. Hope ya'll enjoy And scaling, the inner dimensions from temple to temple are about 185-190mm, so fitment should be fine. If in doubt, print a measuring ring by only letting the top half print for 10-20 minutes and scale up or down from there. Any more questions please feel free to message me.