Quintesson Bailiff Head for Transformers WFC Earthrise Allicon 3D print model

Here's something different to help turn your regular Earthrise Allicons into the Bailiff version, with a simple head switch!

This simple one piece print should be simple enough to pull off and with a little bit of paintwork should turn out quite nicely.

Equip him also with the bailiff spear from before (https://www.patreon.com/posts/45959760) for a more complete look too.

To install this alternate head for Allicon, the original head would need to be popped off (carefully!) by pushing it horizontally from the back to front. Try to not exert too much force on this to avoid snapping the neck peg.

After that, the new bailiff head can be installed in the reverse fashion, pushing it horizontally from the front to back. It can be a little tricky as the horizontal piece the head peg sits tends to want to rotate downwards. If it feels a little too tight, a tad of sanding or even re-sizing before printing may be needed.

For transformation, the bailiff head will need to be rotated so that it is facing sideways before it can fit into the chest cavity. This would be great to use with the Quintesson Pits of Judgement set too! (https://www.patreon.com/posts/44852478).

Hope everyone likes this piece for your Allicons! ;)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog