Bumblebee Mega Cannon from Transformers Comics 3D print model

Gracing the cover from Dreamwave's Transformers #2 from back in the day, we see a little Bumblebee standing triumphantly over a fallen Bruticus, with this magnificent mega cannon in hand!

Almost as long as Bumblebee is tall, this bad boy comes with the option to place handles in three different positions underneath depending on how you would like to pose with it.

The magazine for this has been designed as a separate piece so the cannon can be reloaded after it runs out. As usual, the front of the barrel and the back of the cannon are sized to allow for effect parts to be added too.

As an alternative, a rubber hose with 3mm internal diameter can be used to connect to the rear of the cannon too.

=== Assembly ===

The included diagram shows a look at the parts for this build.

Handles are removable and there are three slots on the underneath of the cannon where they can be pegged into.

===

As always, happy 3d printing this little tribute to an older comic cover art! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog