CyberBase System Shield Generator for Transformers 3D print model

Here's another fun piece in the form of a Shield Generator to add to the any CyberBase System diorama you may already have!

This shield generator features a dodecahedron as an homage to the Allspark, held aloft in the middle of the structure. The quadruple arms around the body energize and help project the protective field when needed.

The provided shield piece can be attached to the central crystal using a 5mm rod cut to length, or by printing the provided 5mm rod piece. To create the translucent energon look, the crystal and shield pieces can be printed in clear and then painted in clear color of your choice (we just used blue here).

And of course, the shield part has a 3mm peg for blast effect parts to be added to it!

The shield part can also also be rotated to give a slightly different look or be connected using the downward facing port on the crystal to block off attacks from below!

=== ASSEMBLY === The attached images shows how the various pieces in this set, and how they are to be assembled:

• There is a central 5mm hollow from the Crystal through the Stem, Strut to the Base so that they can have a single reinforcing 5mm rod to help hold up the entire structure to better hold up the shield (which can be quite heavy).

• Similar the earlier Robotic Tentacle, the whole setup connects to the CBS_BaseTile using a Base-Peg piece.

===

Hope everyone enjoys adding this fun little piece to your diorama and display! Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog