Any suggestion is welcomed! Feel free to join my Facebook group to let me know what you want: https://www.facebook.com/groups/1115757609295068

Custom display base are also available from $5! Contact me to discuss what you want!

If you like my work, you can support me through Patreon or a tip through PayPal: https://www.patreon.com/gigapenguin3dprints

Description

The display should fit with any other Subaru BRZ Pandem of the same casting. Also most Hot Wheels cars shares the same width and wheelbase, so it should works with any sportscar

If you wish to have a display base tweaked to fit to a specific car, please send me these dimension for the display base holes: https://imgur.com/5T6mb2L

The display base is separated into 3 parts for easy printing and colour swap. The parts are:

1) Falken Base Pattern
- FalkenBase - BRZ.STL
- FalkenBase - Falken.STL
- FalkenBase - Plain.STL
- FalkenBase - RX7.STL

2) Base
- BaseV2.STL
- BaseV2 - No Holes.STL

3) Back Wall:
- BoxBackAssem.STL

Falken Base Variant

There are multiple variant of Falken Base, the one printed in my pictures are "FalkenBase - BRZ.STL".

The difference for each Falken Base are:

FalkenBase - BRZ:
Falken pattern with “Subaru BRZ Pandem” written on it, as seen in my photos.

FalkenBase - Falken:
Same Falken pattern but with “Falken” logo written on it.

FalkenBase - Falken:
Falken pattern with no lettering.

FalkenBase - Falken:
Falken pattern with Mazda RX7 logos (Suggested addition from Facebook group)

Print Settings

Nozzle size = 0.3 mm (Should be printable with 0.4)
Layer height = 0.2 mm

Filament change layer for colours on "BoxBackAssem":
1) Start (Left side of the Falken pattern, mine is in teal)
2) Layer 8 (Right side of the Falken patterm, mine is in blue)
3) Layer 13 (Falken lettering colour, mine is in white)
4) Layer 18 (Falken “F” dash colour, mine is in red)

Filament change layer for colours on "Falken Base":
1) Start (Overall base pattern colour, mine is in teal)
2) Layer 9 (All letterings colour, mine is in white)
*3) Layer 24 is for “FalkenBase - Falken only” (Falken “F” dash colour)

Assembly

The car is tied by wires through the hole in the base

Back plate should slide in nicely into the display base. Falken base should slide into the base, best to print at optimal temperature to avoid elephant foot print that might make it hard to fit in.

Others

Feel free to send me any feedback on how to improve the design. Suggestion on display base designs are welcomed too.

I can be contacted through Instagram or Twitter too:

Twitter: https://twitter.com/Giga_Penguin
Instagram: https://www.instagram.com/GigaPenguin3DPrinting/
Facebook: https://www.facebook.com/groups/1115757609295068/