AIRSOFT AT-4 Anti-Tank Launcher

An Airsoft launcher replica AT-4 with almost the same manipulation as the real counterpart. The only functionality that differs is the rear safety ring pull. It is made for a 40mm airsoft grenade by using an included adapter (adapter may not work on all grenades and you might need to model and print one for your specific grenade) This means it can launch anything including the well known Taginn rounds.

The assembly is at medium difficulty, some experience of building project like this is good, but its a good project to learn new things.
there is a video explaining basic assembly, you can find it here:
https://www.youtube.com/watch?v=k2Z8n6HAHX0

I have included assembly instructions, diagrams and decal template.

I would recommend using at least 250x250x250 bed, but you could get away with 200x200x250 print bed.

Tools Required:
-Dremel
-Drill
-Drill Bits Set
-Saw
-Flat File
-Various Grit Sanding Paper
-Primer, Paint, Matt Lacquer
-Hex Key Set
-Philips, Flat Screw Driver
-Scissors
-Soldering Iron
-Thread tapping set
Parts Required:
-Part 01: Metal Rain Water Pipe - od.90mm x t.0.8mm x 870mm
(Bilka Downpipe 90mm https://www.bilka.ro/en/gutter-system/)
-Part 02: Aluminium Round Bar - od.6mm x 145mm
-Part 03: PVC Pipe - od.50mm x 440mm
-Part 04: 5x Spring - od.7-10mm
-Part 05: V-Spring - d.7.5mm 1.0mm, 3 laps 120 degrees
https://www.aliexpress.com/item/1005002974329000.html?spm=a2g0o.order_list.0.0.50d51802pgGakY

Fasteners Required:
-M2 Bolts and nuts
-M3 Bolts and nuts
-M4 Bolts and nuts

Please note that this is a airsoft replica and should be treated as such, no public demonstrations or any other misconduct.

I do not permit resale of either data downloaded or the launcher itself. Please support the creator and if you are making the launcher for someone else purchase another blueprint these kind of projects take a lot of time and resources and I would greatly appreciate this. Thank you.

I have printed this in ASA as it has better temperature resistance and is fairly light this means it will not melt in your car. Some more of the structural parts could benefit from larger infill density, but the beauty of this is that if something break you could just reprint it at better settings and it seems to hold fine on 40% infill.