HI-CAPA 6'' LIGHTWEIGHT SLIDE

LIGHTWEIGHT SLIDE FOR HI-CAPA 6 INCH

This slide made for "WE 6'-1" but it can work with pistols that made on TM/WE/KJW - HI-CAPA/1911 - platform.

(Tested on WE Tech Hi-Capa 6" Inch and TM GM HI-CAPA 5.1)

Slide made for TM standard parts and sights.

To use WE blowback housing, - you will be need to cut front bolt ear on it, or use any TM standard blowback housing - like about lightweight (recomended) - CowCow / Guarder, or any other TM standard housing.

Slide has TM standard rear sight mount, so you can use any slide handle or rear sight for TM Hi-capa/1911.

Slide weight only ~40gramm.

Made to use with fixed barrels.

You can try to use stock pistol parts to assemble slide.

Be careful with PSI over 90.

If you are printing with ABS, it is highly recommended to apply a thin coat of ABS adhesive (dissolved ABS in acetone) to the slide guide for recoil spring and bushing.

I do not give permission to publicly publish or resell the files you have purchased from this adapter. I do not give permission for commercial production of finished products based on these files. Only for personal use.

FOR FDM:
Material - pla, abs (tested, recommend), petg, nylon.
Layer hight and nozzle - a small as posible 0.1-0.12
Supports - YES
Raft - try for ABS

For ABS - Necessary use thermobox.
Adhesive for table: ABS-JUICE (dissolved ABS in acetone)
SLOW DOWN SPEED - wals not higher 30mm/s, overall speed not higher 50mm/s

All settings are approximate, adjust for your printer and test results