EB Triple Threat (EB Ultimate Remix)

1/13/23 (new year folks)

I merged two EB Fan Shrouds together that i found in thingiverse. i tested both and liked each of them, but they each had their limitations. I made sure to make cooler height Adjustable, tested on MK8 Hotends, Included the BLTouch mount, 3 4010 blowers aimed air flow more aggressively the nozzle/molten filament.

this hits on 3 angles FRONT TO BACK, LEFT TO RIGHT, RIGHT TO LEFT. I have printed these in PETG, ABS, and CARBON Fiber. I would not recommenced anything less then PETG and if you can get great Quality i should mention ASA was recommended by one of my followers.

Triple Threat (Ultimate Remix) probe offsets:
X-40, Y5, Z (varies because of adjustable design)

**Tested and working on:
---Creality Spider all Metal Hotend V1
---Haldis Red Lizard V3
---Biqu All Metal Hotend
---Downblade all metal hotend.
---creality stock hotend (slither house tested)
---voxelab
---Xvico x3
---Sunlu S8 Stock hotend
---ender 3 v2 (slitether house tested)
---Microswiss all metal hotend (cooler and older direct drive)

MERGED THESE TWO I DID NOT CREATE FROM SCRATCH (REMIX)
https://www.thingiverse.com/thing:4749257
https://www.thingiverse.com/thing:3419531

VIDEO OF IT IN USE
https://www.tiktok.com/@dope_god_3d/video/7188331173934812459?_r=1&_t=8Z0e3ReZNrm

recomend printed in Carbon Fiber, ABS or PETG at minimum. I printed @ .18 layer height, but have printed at .36 layer height on a .4 nozzle ad obtained decent quality.