FISHING Boilies press 19mm,20mm,22mm,24mm

I recommend you also take a look at
NEW : PRACTICAL FEEDERS (3 types 9 variants )

https://cults3d.com/:1906687

a simple hand press for Boilies that can create Boilies with a small through hole. it is not about pressing balls in large quantities, but suitable for pressing your own recipe a few pieces to test whether they take the fish well. Without a problem, you can do about 20 - 30 Boilies. The dough can be created by sifting the mixture into a fish feeder of various flavors and add a little flour and water

a simple hand press for Boilies that can create Boilies with a small through hole. it is not about pressing balls in large quantities, but suitable for pressing your own recipe a few pieces to test whether they take the fish well. Without a problem, you can do about 20 - 30 Boilies. The dough can be created by sifting the mixture that is used in the fish feeder of various flavors and add a little flour and water.

I recommend then these balls to steam for a few minutes (10minutes + ) and then dry in the sun or radiator .

The mixture must have flour in it.
You can add eggs if you like, but the most important thing is the flour. I'm sure you can find some recipes on the internet.

From the mix I've done, I've never once had it stick inside.

All my fishing equipment

https://cults3d.com/en/design-collections/bionicfactory/fishing-equipment

news: Add 20mm press
Add 22 mm press
add 24 mm press
All my fishing equipment https://cults3d.com/en/design-collections/bionicfactory/fishing-equipment

3 wall
infill 40 %
layer height
3 top layer
3 bottom layer
material PLA
for printing I recommend CURA

I don't have time at the moment :P but later I will add other sizes to this project .Can you make this press in slicer bigger or smaller cc -10 - 20%