OnePlus 10T PALS Armor Plate Carrier Phone Molle Mount

This is a simpler version of the original PALS Armor holder. It would fit your OnePlus 10T just fine. In addition to 3d print you will also need some kind of pin, or a 4mm diameter rod to create a hinge.

example of threaded Insert: https://www.amazon.com/M5x5-8mm-OD7-1mm-Threaded-Plastic-Staking/dp/B08T9W17CR

example of M5 bolt:https://www.amazon.com/PZRT-Button-Socket-Screws-Stainless/dp/B07F72LQX6

example of 4mm rod (you need at least 60mm lenght): https://www.amazon.com/TOPPROS-100mm-Stainless-SteelSolid-Round/dp/B087JPV9MS

There are two designs in catalog - with,and without camera holes.

Unfortunately, the arrangement of the buttons on the OnePlus 10T causes that while phone is in holder, there is no acces to volume buttons.

Photos are from my various previous creations for Iphone 7, XR, 13, Samsung S22 ultra, S10+, Z fold2, and others, just because i didn't print this one yet.
There are also other designs on my account so go ahead and check it out if you want.

If you want me to create a model for your phone please feel free to contact me.

Remember. This case fits only OnePlus 10T

3D PRINTING SETTINGS
best to print with ASA or ABS
first layer must be 0,1mm to have camouflage look. other layers as you want, but best 0,2
manual supports on body hinge, "wings" on molle mount, and body to armor hook - see attached photos

best to print with ASA or ABS
layer thickness 0,2 works fine.
manual supports on body hinge, "wings" on molle mount, and body to armor hook - see attached photos