PS4 Video Game Case Bookend Organizers

These are a fun and simple print for your video game case storage and display! If you are the type that likes to show off your games in all their glory, this could be a fun way to stand out from the rest of the typical storage devices out there.

Also makes a great gift for a gamer friend!

Layer Height: 0.28mm or .020mm (smaller is ok to)

First Layer Height: 0.30 (for a good squish for adhesion)

Top layer Count: 4

Bottom Layer Count: 3

Seam Position: Back

Wall Count: 3 minimum so that no infill pattern shows through the skin

Supports: yes, build plate only

Infill Density: In order to provide enough weight to the product so that they effectively hold video game cases upright, it is recommended to create about 40% infill about 1/3rd of the height of the part. This will give it a good low center of gravity. Subsequent upper layers can use 15% infill. Total filament used should be at least 125grams per bookend (250grams for the pair).

Build plate adhesion: If you have excellent adhesion on your printer, then no brim or rafts are needed. If you have trouble with adhesion then it is recommended to use a brim, since the corners are so sharp and have a tendance to lift. If you still are having warping issues at the sharp corners, use a raft.

Temps/Speeds: Use filament recommended temps and speeds.