Magazine (6-bolts) for ManKung Alligator 2

This is a magazine for the alligator 2 that can hold 6 bolts (6,3"-6,5"). The magazine can be opened up if necessary, e.g. to be able to wax the rail more easily. In addition, the magazine has various picatinny rails that offer a wide range of equipment options. A sighting aid is not absolutely necessary because the magazine has rear and front sights.

Brand new: now with optional safety device (see pictures and parts list in the description down below).

Important: You need the trigger part from tuning trigger v2.1 for the safety device

In order to function properly, the slider must be lubricated very well with silicone grease!

short demonstration on YouTube

assembly instruction

If you don't want to melt instert into the pistol body, you can do without the knurled screw and simply use a longer wood screw like the original (4x25mm lens head).

Before you buy the magazine, please read the following section. An updated assembly instructions will follow

-Make or buy the magazine spring (e.g. as a spare part from Steambow). Drawing is in the zip file.

spare part kit e.g.

If you buy the kit, you can use the magazine lid spring and the metal hook, too!

-It would be good if you were able to print a small part from TPU (but not absolutely necessary).

Parts list:

lens head srews:
7x M3x6mm
6x M3x10mm
2x M3x16mm
4x M3x30mm

allenscrew:
1x M3x20mm
1x M4x40mm

nuts:
19x M3
1x M4 self locking
1x melting nut M3

washer:
2x M4

dowel pin/nail:
1x Dia.3x33mm
1x Dia. 3x16mm
2x Dia. 2x12mm

for safety device 1x Dia. 3x28mm

optional wood screw 4x25mm lenshead

magazine spring:
you can use the original steambow stinger 2 magazine spring (spare part) or make a new one

magazine lid spring:
you can print it with ASA/ABS or Greentec from Extrudr (not Greentec Pro) or buy the original spring from steambow (as a spare part)

If you make the spring by yourself (magazine spring and stopper spring) follow the link for the stuff you need (0.5mm thikness):

stuff for the spring - metallstore24

0.2mm layer height
0.4mm layer width
5 wall lines
5 bottom/ top layers
infill 30% cubic

partial support structure needed

print settings for safety device:

0.1mm layer height
0.4mm layer width
without infill