Miniature Bottles for Dioramas and such / Miniature bottles for dioramas and such

As I wrote in the title:

miniature bottles for dioramas and such. Scale approximately 1:10.

Both are hollow and very easy to print. No vase mode required. One represents a 0.5-1.5l PET bottle with the typical 5 bumps on the bottom and the taper towards the top, the other a 0.5-0.75l cocoa bottle.

Depending on how you scale them.

At 100% it should be a 0.5l cocoa bottle and a 1.5l PET bottle. In the photo you can see the PET bottle scaled to 70%.

The bench and the garbage can, as well as the water pipe and a lot of other stuff can also be found (soon) in my files,

Your purchase gives you the right to download and print the design for your personal use only. You do NOT have permission to sell prints or redistribute the digital files in any way.

As schion described in the title; miniature bottles for dioramas and such. Scale about 1:10

Both are hollow and very easy to print. No vase mode required.

One represents a 1 -1.5l PET bottle with the typical 5 bumps on the bottom and the taper towards the top, the other represents a 0.5-0.75l cocoa bottle.

Depending on how you scale them.

At 100%, it should be a 0.5l Cacao bottle and a 1.5l PET bottle. In the photo, you can see the PET bottle scaled to 70%.

The bench and the trash can, as well as the water pipe and a lot of other stuff you can also find (soon) in my files,

no vase mode,

0.4 or 0.6mm nozzle,

For PLA 185-190° and 9-22mm/s

Glue or brim for the bed if there is no adhesion. The contact surfaces are very small

No vase mode,

0.4 or 0.6mm nozzle,

For PLA 185-190°C. 9-22mm/s. Adhesive or brim for bed in case of no adhesion. The contact areas are very small