Doctor Who Tablet Stand

This was just a quick design. I couldn't find any Dr Who related tablet stands so I made a quick one.

2/10/2018 - I printed version 3.1 with the same settings and it works a lot better. I realized that I really do not need to have the tablet upright. It does work standing up BUT it isn't very stable and will fall over with a small tap. However, it does make sitting sideways a lot more stable and will be the one I use for my Galaxy Tab 3. At this point I am marking it as complete. Enjoy and let me know if you give it a try!

2/9/2018 - I did a test print and it seems to work "OK" for now. I have a Galaxy Tab 3 8inch that works well sideways. However standing it upright tips the stand. The same goes with my ZTE ZMax Pro phone as it is a large phone. I will be making some changes to the base in order to accommodate this tablet. Larger tablets may need additional changes. I am not sure I will get into that as it could just work as a quick size increase based on what tablet you are using.

2/3/2018 - I changed the design a little to save on filament that may not be needed. I also expanded the area where the tablet sits a little more. I will be doing a test print shortly to make sure it works. I also left the previous version in case anyone likes it more than the new version's design.

2/2/2018 - I have not tested version 1.1 but the first did not fit my tablet. I made some adjustments and will be printing a new test shortly.

-