Vertical Lithophane Lamp

This design is an illuminated case for lithophanes. This way you can display a photograph of a special moment in an original and elegant way in any room of your home. The dimensions for the lithophane are 100mm x 140mm (default settings on https://itslitho.com). The case is designed to allow the lithophanes to be interchangeable. To fully assemble the case you will need the following:
Printable:
Case
Lid
Horizontal beam
Lithophane
Electronics:
2 Led strips 10mm each
1 Led strip connector
1 Switch
1 Plug adapter
1 12v Power Adapter
Tools:
Soldering iron
Tin solder
Small phillips screwdriver

Dimmensions in mm

Height Width Depth
Vertical 145 112 100

Lithophane iluminado
Este diseño es un case iluminado con leds para litografías o lithophanes. De esta manera se puede mostrar una fotografía de un momento especial de forma original y elegante en cualquier habitación de tu hogar. Las medidas para el lithophane son de 100mm x 140mm (configuraciones por defecto en https://itslitho.com). El case esta diseñado para permitir que los lithophanes sean intercambiables. Para ensamblar por completo el case se necesita de lo siguiente:
Imprimible:
Case
Lid
Horizontal beam
Lithophane
Electrónicos:
2 Tiras de led de 10mm c/u
1 Conector de tiras de led
1 Interruptor
1 Conector de corriente hembra
1 Eliminador de corriente a 12v
Herramientas:
Cautín
Soldadura de estaño
Pequeño destornillador de cruz

Dimensiones en mm

Alto Ancho Profundo
Vertical 145 112 100

I print it using PLA (use your temp settings), no supports. I print the whole case in the same run and the lithophane in another print, mainly because of the PLA color. For the assembly is a simple circuit you conect the source to a positive pole of the leds, other part of the source goes to the switch and thats it. You better try to make a test of the circuit before the assembly.