Worker Dominator Solenoid and Sensor Mounting Hardware

These are some of the components I am using for my triple brushless Worker Dominator.

Warning: This is a significant modification to the Worker Dominator - you cannot go back.

If you should choose the triple brushless setup, please be aware that serious injury may occur to the user and or others nearby.

Dominator Chrony LED Holder
Print with the round side down. Use supports if you like. Whatever infill you like - it's not structural. Any Nerf blaster can accept this on the standard barrel. Use the hole guide to make sure your barrel holes are correctly placed.

Dominator Console Parts
Not structural - print how you want. This is to mount 3 buttons, an oled screen, and a select fire switch to the left side of the blaster.

Dominator Sensor Parts
Not structural. These will mount a selection of IR sensors into various positions on the dominator.

Dominator Solenoid Parts
Structural. Print full infill. The nub will glue onto the brass pusher end on the solenoid.
The only supported solenoid is a 35mm ebay / ali express unit.

AFG
This is a remix of the Caliburn AFG to suit the length of the dominator.

Electronics Cover
This is an extended battery bay cover to allow for a bunch of electronics. There is a cut-out to allow for a USB-B port. I suppose you could use it as a battery extender. One is plain, the other has a Hello Kitty on it.

Installation
This is early days, and I haven't got the blaster running fully yet. You can follow my Swordfish Solenoid Install guide to have a basic idea on what you need to do. But you're really on your own at the moment.

License
All these components are my own designs, and therefore no commercial use is allowed.

Except for the AFG.. Which follows the Caliburn license.

-