Blink mini wall mounts (3 designs)

3 options to mount your Blink mini to the wall, all have holes for countersunk screws or strong double sided tape can be used as well. The camera base slides easily and is held by the top and two rails on the bottom. It should not scratch the plastic if dimensions are printed correctly.

Design 1 - 90 degrees closed.
Slide the camera before mounting the base to the wall, it is completely trapped.

Design 2 - 90 degrees open front.
The mount can be attached to the wall without the camera, it has an opening in the front so you can install and remove the camera. It is still held securely by friction.

Design 3 - 45 degrees open back.
Can be mounted without the camera installed. It has space on the back so you can mount it later. This design allows for the camera to be pivoted beyond the limited range of the ball joint. It can face down if you want. Again, very secure hold.

Print in PLA only if it will be used indoors with temperatures below 38°C (100°F), otherwise use PETG for higher temps or ASA for direct sunlight exposure. 3 external walls and 12% infill gave me good results. It is better to print in the same color of the wall, not black as my pictures. I printed them as the pictures with a 5mm brim and supports, you can try it also on its side.