Pika Trash Bin

The garbage can consists of three printable files. Two of them, the head and the top cover, require supports. The body of the wastebasket is printed on-site.

Want to make a change in your setup? Introducing the pika garbage can!

This fun garbage can is the perfect size to accompany you on your desk, next to your 3d printer or even in your office.

The capacity of this garbage can is quite large for a desktop garbage can, maybe a little small for a conventional garbage can, but if your printer is large in volume, you can scale it up!

The model is carefully designed to save material during printing, due to its large size. The total set requires about 300-320 grams of material, depending on your media configuration.

IMPORTANT NOTE:

The garbage can head, measuring 25,9cm from side to side, on an ender 3 type printer you have to print it diagonally. If your printer is a large format printer, no problem.

This file includes a gift to match the garbage can, called Pika-Mug, a mug with the same theme that is perfect to go with this garbage can, and that you can find in my cults profile.

All my designs are covered by a Creative Commons non-commercial license. If you wish to sell my printed models separately, you require a written authorization by me.

If you want to sell my prints, you can get a commercial license as long as you have an active Patreon subscription https://www.patreon.com/sheikoner

Layer height 0.2

Nozzle size 0.4

Speed 50mm/s

VERY IMPORTANT At the head of the garbage can, increase the wall perimeter to 4 or 5wall lines offset, and place brackets everywhere.