disk launcher 2.0

This is a remix of bongoboy23's (https://www.thingiverse.com/bongoboy23/about) disk shooter (https://www.thingiverse.com/thing:7643).

The main improvements are less filament used, better tolerances, a finger ring to pull the slide back, there are two versions, one is integral to the slide, the other is a add on for the original slide, and i also improved the connection between the handle and barrel. You can currently use the scad file for the finger ring slide (need a better name for that), more will be included at a later date such as the handle, ammo holder, and ammo discs.

If i feel like it, i may make a mechanism that lets you cock it without actually firing it. I may also make a scad file for the finger ring and slider with built in finger ring for sizing (done!). and if i can figure out how, i may make a scad file for customizing the disks with a image, don't know if that's something i can do yet.

You can make requests, i'm open to all and any input, and feel free to remix to your hearts content.

Please note that i'm still working on this, and will be changing file names eventually.

For now, you will need to scale most of these pieces for optimal performance, i'll be tweaking them in the future.

Print the handles at normal scale.

Print the barrel at normal scale.

Print the slides (not the scad file) at 102%

Print the finger ring at the same scale you print the slide at.

Print the auto_reload_base at regular scale.

You can use the ammo at regular scale, but maybe experiment with different scales, i haven't done that yet.

Print the lid of the base at 97%.

The scad file should be fine, i haven't fully tested it yet, but it seems to be good.

-