Modern Ceil Lamp over classic Ceiling mount

I have an old classic metal ceiling sockets in all my hose. Those ar classic cheap market lamps. I Wanted to get my ceilings lamp prettier without replace all of them. So I designed a lamp that is mounted over the old socket lamp.

I wanted it to fit a classic printer so it is a 200mm diameter.

it is:
- very economic to print (small amount of filament needed to make it)
- easy to print (no supports, bridges and so on)
- no need of screws
- it can be demounted with no ceiling or old lamp damage at all

it has:
- easy to mount and replace shade, so u can replace them in a seconds
- optional bulb cover that U can "design" by yourself from 3d printing infill (details in 3d printing settings section)

The original ceiling lamp is 90x90x5mm, but it can be easily adjusted if u have a little 3d modeling skills. (I can make different mount sizes at demand too)

!!!
It is designed to led bulbs because of low heat. Classic bulbs gets too hot for PLA or PETG filament. U can try with ABS, but U have to test it for long runs for safety. I have not tested them in such conditions!

Mount:
- at least 2 outline layers
- 0% infill is enough

Reflector:
- at least 2 outline layers
- 100% infill (circular)

Shade:
- at least 2 outline layers
- 100% infill (circular preferred)

Cover:
- at least 2 outlines
- 0 top infill layers
- 0 bottom infill layers
- infill pattern will be your cover design pattern ( mine was about 5% hexagonal or bicubic)