Cannabis Cone/Joint Flask with Lighter slot

This cannabis cone flask is designed to hold five(5) pre-roll cones and one standard bic style lighter. I designed the flask for my cannabis business, now I'm sharing it with community. The flask is designed with a curve to conform to your leg (front pocket) or butt (back pocket). It fits perfectly in a small purse.

The lid is designed to accept a piece of oder reducing filter fabric without interfering with cones.

The case also has small tabs to keep the lid closed.

The inside dimensions are 100mm deep, but will hold king size (109mm) cones due to the design of the lid. While the flask can hold joints, and blunts, it designed for cones as the holes are smaller at the bottom of the flask.

The flask can be printed on any standard printer settings.
Flask Settings
The flask bottom prints upright
Support - no
infill - 10-15%
filament - PLA (PETG if you're leaving it the car for long periods)

Cap Settings
Support - Yes (suggest orientating lid with top down. this will reduce support cost and make it easier to remove.)
Walls - 3 (no more than 4 as it make the lid very snug)
Filament - PLA (PETG if you're leaving it the car for long periods)

Print time on my Ender 3 pro is between 7-9hrs @60mm/sec
Print time on my CoreXY (BambuLab X1C) about 3-4hrs

Note: The seam should be set to the back (inside curve).