GGO Photon Sword (Extending Blade)

The Photon Sword Kirito uses during the Gun Gale Online arc from Sword Art Online, now with a fully extendable blade!!! (i have not tested it at the time of upload due to my lack of filament :b)
unfortunately, in order to make the design printable without supports, i had to remove the ports for the belt clip, but in my next iteration ill either add a print in place clip, or re-add the holes.
I know the emitter isn't screen accurate. i just edited the original model to fit the blade, so ill improve the design as some point
This uses the exact same screw systems ass all the other extending lightsabers, so if you wanted you could make this double bladed by using this!!!
https://www.thingiverse.com/thing:5356420

I used the Photon Sword by d4rk0s: https://www.thingiverse.com/thing:409762 for the outside design

I used 3DPRINTINGWORLD's lightsaber: https://www.thingiverse.com/thing:3668138 for the blade

and I used my own template made from that lightsaber as the base for all the technical bits! https://www.thingiverse.com/thing:4945470

-----Instructions-----

(Both the Body and Pommel should print with little to no problems without supports)
Download the Body, Pommel, and Blade
make sure to print both the Body and Pommel in the default orientation, anything else might compromise the performance of the blade extension
Make sure your printer's Tolerances are good before trying to print the Blade. if the sections keep sticking to each other, try printing each one individually, you can find them here: https://www.thingiverse.com/thing:3668138

-