Vertical GPU Mount - Lian Li O11 D EVO

A GPU mount designed for the Lian Li O11 EVO for reorienting your GPU to be vertical while maintaining support for other smaller PCIe devices. This Mount takes up 6 horizontal slots and provides 4 Vertical slots. Though this is designed for the LL O11 EVO it may function in other PC cases with little to no modification.

This mount makes use of a 15cm LINKUP PCIe 4.0 X16 Riser Cable and supports the use of a second, single-slot PCIe device such as an Elgato HD60 Pro. I only have a 2-slot GPU so I am unable to test for fitment with a second PCIe device and a 3 or 4-slot GPU configuration.

Secondary PCIe Device Notes
Devices of x16,x4,and x1 form factor can be used so long as they are single-slot. I have not tested 8x or made a support bracket. (links to various risers found below) You will need a second riser of the proper form factor in order to use a second device. Note that the extra single-slot device can only be used if there is clearance for the x16 riser cable, which usually means there must be an unused vertical slot between the two devices. (see pictures for recommended configuration)
The secondary device must also be installed into the bracket before it is mounted to the case due to the screw being inaccessible after installation.

Hardware
The only hardware you need are Metric 3mm (M3) Countersunk Screws (though other M3 screws with different heads will work)

M3x14mm*2 (PCIe Standoffs) 1 set per device mounted
M3x6mm*3 (RiserSupport + Riser A) screws can be longer
M3x6mm*3 (RiserA + RiserB) screws can be longer

Misc Notes
Note that a 15cm Riser is recommended for the GPU, however in the pictures a 20cm Riser is installed due to components I had on-hand at the time. if you plan to use a 20cm riser understand that it will have to be doubled over in order to fit in the space given like the example picture.

Please understand the bracket is designed around the risers listed below and that though other risers may fit, the screw holes may not line up perfectly. Obviously I cannot guarantee fitment for risers other than the ones listed. Feel free to message me if you have questions.

10/23/23 - Added PCIE_GPURiser3A which features a thicker top bar where the GPU securing screws are attached to prevent breakage. Note that this may not work for cards with ports near the screw bracket as they may be blocked by the adapter.

LINKUP - Ultra PCIe 4.0 X16 Riser Cable
https://www.amazon.com/gp/product/B08YZ5S29D

Mustpoint PCI-e PCI Express 36PIN 1X Extension Cable (Dual Vertical 90 Degrees Direction)
https://www.amazon.com/dp/B07ZHVZR69

Hot PCIe 3.0 x4 Extension Cable
https://www.ebay.com/itm/304633464177?var=603664641099

This is best made out of something like PETG, PCTG, anything with enough heat resistance and rigidity to exist in your PC long-term.
This mount will function out of PLA, however I would not recommend it due to temperature warping.