It's a Wonderful World organizers, V.2

Organizers for It's a Wonderful World board game, version 2. All organizers fit the game box very well, provide quick game setup and comfort during the play.

The set contains: Resource organizer and Card tray.
01. RESOURCE ORGANIZER: All resources are accommodated here in separate sections. Rounded bottoms facilitate item draw. Sliding lid prevents components from falling out during the storage. Decorative cutouts are related to pictures on cards.
02. CARD TRAY: All cards are divided into 2 decks (e.g. to fit the game box). Sloped bottoms and indentations facilitate the draw. Empire cards, small pencil and Score pad are kept in the side section. Indentations facilitate taking components out.
The default file WW.Cards.stl is dedicated for cards without sleeves. There is also WW.Cards_InSleeves.stl - it is 22 mm higher, so all cards in sleeves should fit it. It is based on my previous measurements made for version 1, available here. However sleeves made me furious, so I got rid of them. Please note, that this way too large game board may cause problems with full closing the box completely (with the card tray for cards in sleeves only! of course).

Some photos in higher resolution:
The set
Resources organizer
Resources organizer with sliding lid
Card tray
Packed

All organizers fit the game box very well, however it's not an insert.

All organizers were 3Dprinted on Prusa MK3:
- in PLA (F3D Gold pearl)
- No support is needed,
- Infill 10% rectilinear.
Note1: I use slightly changed default Print settings "0.15mm SPEED MK3" in PrusaSlicer.
Note2: I use Monotonic top fill to increase lid's quality.
Note3: The length of organizers is ~236 mm.

Printing Time (for one organizer of each kind):
16h10' - Resources, Container
5h7' - Resources, Lid
10h31' - Cards