Aircraft Wall Art

My attempts to learn the basics of Inkscape and Fusion 360 to create aircraft wall art.

I am a fan of airplanes. I spent 26-years as an aircrew member (Loadmaster) on both the C-5 and C-17 and currently I teach people how to build Boeing aircraft.

Please don't print and sell these for a profit. I am sharing them with the community for everyone's enjoyment.

If you print one and are inclined, please share your settings and maybe a picture.

Aircraft Types:
C-5 Galaxy
C-17 Globemaster III
C-141 Starlifter
C-130 Hercules (with and without MLG extended)
B-52 Stratofortress
RV-8
A-10 Warthog
787 Dreamliner
F-16 Falcon
SR-71 Blackbird
F-22 Raptor
KC-135 Stratotanker (for all my Boom friends who actually believe that NKAWTG nonsense!)
Added 7 Jun 23
737 (3 types)

AH-6 "Little Bird" (first attempt at a helo)

Most of the pictures are smaller and faster test prints.

Printer brand:

Creality
Printer:

Ender 5
Rafts:
No
Supports:
No
Resolution:
.16
Infill:
20-25%
Filament brand:

Overture
Filament color:

Black
Filament material:

PLA Plus
Notes:

I am printing on a stock Creality E5+, with a glass bed (smooth side up). Some I printed with a brim and some I printed without a brim. I found a brim helps with with adhesion because I do not use anything like glue or tape, but it is a pain to remove. The last one I printed (the 787 photo) I did without a brim but I bumped my bed temp up to 70 and did not have any warping. I usually print about 68 as my bed runs a little cold according to temp readings, so I will try that again next time.