Transformers Energon Omega Headmaster Parts (Omega Supreme & Omega Sentinel)

Replacement parts for Transformers Energon Omega Headmasters. They will work for both the Omega Supreme and Omega Sentinel decos / molds.

Parts Included:
ener-omga-01-04-01 - Lower left leg
ener-omga-01-05-01 - Lower right leg
ener-omga-01-06-01 - Upper Right leg
ener-omga-01-07-01 - Lower Left leg
ener-omga-01-08-01 - Face Visor
ener-omga-01-09-01 - Replacement hip ball joints

Note 1: Each leg requires an M2x8mm screw to assemble.

Note 2: I designed ener-omga-01-09-01 because the hip ball joints on my original headmaster figure broke off. I've included this piece in case yours have too. Installing this piece requires drilling through the waist with a 5mm drill bit and the drilling a 2mm hole normal to the 5mm hole for a securing bolt. A tedious operation but it will get you new joints.

With all pieces, sanding may be required for a good fit, depending on your printer and settings.

This model is not to be uploaded or sold in any form and is intended for personal use only.

Other parts I used to restore my Omega Sentinel (but didn't design):
Headmaster arms: https://cults3d.com/en/3d-model/art/transformers-energon-omega-supreme-headmaster-arm

Missiles: https://www.thingiverse.com/thing:5359608

Conning Tower flap: https://cults3d.com/en/3d-model/art/energon-omega-supreme-conning-tower-panels

I printed this model in 1.75 mm black, gray, and red PLA Plastic, with a .4mm nozzle filament printer. Support material required. Different print orientations may vary results, sanding may be required after printing.