Squid Game - Front Man Mask
Squid Game - Front Man Mask
3D
Published 2023-02-13T11:32:15+00:00
I attempted to make this mask as 'show-accurate' as possible, although I'm sure there's still room for improvement so I may revisit it in the future! The mask was designed to print best-oriented upside down, and will need supports to hold it up and in the eyes! I have included photos of how to best deal with the supports. The mask fits my face perfectly with a little bit of room to spare. You can always scale up or down, or use a heat gun to make minor adjustments if needed! The 'grates' for the eyes print separately flat on the build plate, I figured this was the best way to make them look great.
**This design is uploaded with a non-commercial license. Purchasing this file does not grant you the right to sell commercially.
If you would like to consider gaining access to ALL of my models and the rights to print and sell them, you can check out my Patreon at
https://www.patreon.com/thinair3D
Printing Info:
These are just the settings I used to test the model, feel free to use whatever settings work best for you.
- FDM or Resin: FDM, or large format resin. Not much detail though, so no real need for resin.
- Scaling: Current size is 155 x 91 x 222
- Supports: One the bottom and in the eyes. I also used a raft to help improve adhesion.
- Infill/Perimeters: I used 15% with 2 perimeters
- Nozzle Size: 0.6
- Layer Height: I used 0.30 and it turned out well, but a finer layer height will look better depending on your print quality and filament.
Printing, Assembly & Post Processing
- The mask prints best upside down (should already be oriented that way) with supports underneath and in the eyes. Please see the photos in the main folder for a snapshot of how I did my supports.
- The strap slots DO NOT need support if you keep the mask oriented the way it is (they will bridge), so make sure and block supports there if you want a clean bridge. If you have to rotate the mask to fit your build plate they may need supports.
- The eye 'grates' print separately, flat on the build plate, and need to be glued into place afterward.
- The strap slots are big enough to accommodate a 1". I used a stretchy strap I found on Amazon!
| Date published | 13/02/2023 |