Food Film Dispenser

**Zip-Cut or Jet-Cut Food or Aluminum Film Dispenser

It crumples, sticks or rolls up on itself... Food wrap has a way of annoying us. But that was before my reel. If you're tired of throwing away the cling film because the cardboard is broken or has taken water. I propose you here, a more solid unwinder, it uses the original film cutter. This one comes to clip or stick on one of the 4 aluminum bars that make up the assembly.

Universal and adjustable in width.

Hardware required;

12 wood screws 3 X 16 mm

Flat aluminum profile of 19.5 X 2mm

19.5 X 1.5 mm aluminum angle profile

Non-slip pads to be glued underneath.

Non-slip pad

You can set the width of your reel according to the width of your roll by cutting the aluminum profiles to the width of the film + 38mm.

For the brands I mention below you have to cut at 340mm.

There are 2 diameter reducers in the file.

For Nat-Pro Chef, no reducer

For Reynolds you need the 32mm diameter reducer which can be turned in both directions.

There is also a 38.5mm diameter reducer and a 24mm male ring.

If you have A roll with a diameter larger than 46mm, or if you need a reducer of another size, please send me an email.

Parameterizable Food Film Dispenser For different brands.

Already delivered with a Zip-Cut.

Jet-Cut

Nat-Pro

ECOOPTS

Or with any brand of film with these Zip-Cut.

Jet-Cut

or

Zip-Cut

You can use the glue-on or clip-on models. To glue on the angle, to clip on the flat profile.

Wall 1.2

0.2 Height of the layer.

Filling of 25%.

With supports and 80° cantilever angle.

There are very few supports and they are easily removed.