Great Western Trail 2nd Edition + Rails to the North - Insert & Organizer

As the title says, folks!

I've created a replacement insert for GWT 2nd ed + RTTN 2nd ed that aims to accomplish a few key tasks:

• Quick set-up & tear-down
• Storage with sleeved cards (1)
• Support for storage of metal coins
• Tray use during gameplay (2)
• Vertical Storage (3)

Print one of every tray, except Orange.stl which must be printed three times. Note that the player trays are relatively identical, but mirrored to be able to store the solo board in-between them.

The trays have been split up to fit on medium-sized printers. A minimum width of 214.00mm must be supported.

Small Update:
For the Cards tray, there is an option of printing the full tray (230mm across) or printing the LEFT and RIGHT

Design Notes:
1. Designed for, and tested with 60 micron Sleeve Kings sleeves. Larger sleeves may fit when compressed.
2. Card tray, coin trays, and player trays may be used during gameplay to organize components while playing.
3. Very important one for me, Vertical Storage. That said, my copy came with two sets of rulebooks and appendix sheets. Only one set is supported in the insert. Now this one here is tricky, as this game has SO many components, and so little box space when considering the two game boards. As such, the lid lifts by about 1-2mm when all rulebooks of one language are stored. If the rulebooks are stored elsewhere, the box closes flush.

For more info on the insert, check out my thread on BGG: https://boardgamegeek.com/thread/3028565/custom-insert-design-rttn

Update:
Per a request, I've added a picture guide (inside Guide.zip) that can be used / printed, to know what goes where. Please let me know if this was helpful. I'll try incorporate icons in future designs as I have before, but the walls in this one were quite thin already.

Printed at 0.2mm layer height
No supports necessary
I used a brim for the Tile Bags.stl, to keep it from lifting.

Pictured insert was printed on an AnkerMake M5