Buffed n Braced Einsy Door - Use with stock MK3s Einsy Base

This is a buffed/reinforced, braced Einsy door mod to brace the Z axis to the Y axis. Just use your stock Einsy base with this. This prevents the Z axis from wiggling and should improve your prints. I tried to keep this as simple as possible and instructions are below. It takes only a few hours to print. It works just as I intended and it really stiffens the wobble a lot! It is my favorite mod I have done because I consider it a requirement because it affects print quality, and not a just a nice to have.

The door is modified to be stronger and thicker around the perimeter, the hinges are removed and it now attaches directly to the Z and Y frames, with the help of a small frame insert. You don't need to disconnect any cables from your Einsy case!

You will need:
- two m3 12mm screws (m3 10mm will work ok)
- two m3 hex nuts

Also check out my side mounted MK3 LCD mod
https://www.thingiverse.com/thing:3483560

Now you can mount a Logitech or any camera with a screw mount securely to the front frame, as well as place you Pi there for Octolapse:
https://www.thingiverse.com/thing:3518161

My cable clip keeps your LCD cables tidy:
https://www.thingiverse.com/thing:3485143

My feet mod for reducing all vibration and noise by 95%, possible improving prints:
https://www.thingiverse.com/thing:3496474

Fusion 360 File included for remixing.

-