i3Mega Filament guide for Wall Mount | Filament guide for ceiling mount

Hi everyone,

I have created a filament guide that can be mounted on a Anycubic i3 Mega/Mega S.

you will need that guide if you use a ceiling mounted spool holder like i have designed it here:

https://www.thingiverse.com/thing:4704137

The benchmark SD card holder you can find here:

https://www.thingiverse.com/thing:4787018

You can screw the holder on existing screwholes, and for the small guides you will need some double sided adhesive tape to guarantee a safe fit.

There are 8 different parts to print:

• 1x SH_Ulenkrolle | filament pulley with ball bearing 624

• 1x SH_deflection protection | filament pulley guide

• 1x SH_Distancer | Spacer for the ball bearing

• 1x SH_Filamentfuhrung_B | filament guide for the extruder

• 1x SH_Filamentfuhrung_Haken_ben | upper frame guide

1x SH_Filament_guide_hook_down | lower frame guide

• 1x SH_Filament_sensor_holder_base | filament sensor baseplate

• 1x SH_Filament_sensor_holder_clip | filament sensor cable clip

You will need these extra parts:

• 1x 624 Roller Bearings Ø4 x Ø13 x 5mm

• 2x M3x18 screw

• 1x M3x8 screw

• 3x M3 nuts

• 2x M3 washers

• some piece of double-sided adhesive tape

German

Servus,

I have designed a filament guide / deflector that can be mounted on an Anycubic i3 Mega / Mega S.

You will need this baffle if you are using a ceiling mounted spool holder like the one I have designed here:

https://www.thingiverse.com/thing:4704137

You can find the SD card benchmark holder shown here:

https://www.thingiverse.com/thing:4787018

You can screw all the holders to the existing screw holes. For the small guides, you will also need double-sided adhesive tape to ensure a secure hold.

8 different parts must be printed:

• 1x SH_deflection pulley | Deflection wheel with ball bearing 624

• 1x SH_deflection protection | Protection for the filament

• 1x SH_Distancer | Spacer for the ball bearing

1x SH_Filament_guide_B | Filament guide for the extruder

• 1x SH_Filament_guide_hook_top

• 1x SH_Filament_guide_hook_down | If you do not want to use a filament sensor, simply print 2x "SH_Filament_guide_hook_up"

• 1x SH_Filament_sensor_holder_base | Filament_sensor_base_plate

• 1x SH_Filament_sensor_holder_clip | Filament_sensor_cable_clip

Additional parts required:

• 1x 624 ball bearing Ø4 x Ø13 x 5mm

• 2x M3x18 screws

• 1x M3x8 screw

• 3x M3 nuts

• 2x M3 washers

• some double-sided adhesive tape