PlayStation 5 Crystal Dock - Disc Edition - No support

Print-in-place
No Support Needed
It's only for the PlayStation 5 Disc Edition.
Not the PlayStation 5 Digital Edition.
Check my designs for other consoles

Super easy to print in any color to go along with your TV setup!
The model was carefully designed to insert the Playstation 5 like a glove. It is a proper stand; your PlayStation won't fall when docked.
The design does not block AirFlow. The PlayStation 5 sucks fresh air from the front and blows the hot air at the back. I added a security indent on the bottom, just in case.

There are 2 parts.
You need a minimum build volume of 18x18x18 (a Prusa Mini, for example)
No support at all; just deactivate them.
I recommend some infill (printed with a Giroid pattern at 10%)
Make sure you do not have any elephant foot to link the 2 parts properly.

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the Thangs Membership:
🔵Thangs - Membership

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed to print this dock. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.