Wat Pho Temple - Bangkok , Thailand

The Wat Pho Temple is one of the most important in Thailand, it is located in Bangkok next to the Grand Palace. It houses a 46m long Reclining Buddha and the biggest collection of Buddha statues of the country, all of them covered in gold leaf. This is a homage to Thailand, its people and culture!

This set contains 14 models - check out this list to print the right quantities and know how to assemble them correctly:
x1 4 cardinal salas (looks like a cross of 4 long salas connected by a rectangle of thin halls)
x4 cross chedis (a small cross with 5 spikes)
x2 giants (a piramidal spike)
x4 L salas (a sala shaped like an L or corner)
x1 Phra Maha Chedi (4 big, detailed chedis ordered like a T surrounded by small halls)
x1 Phra Mondop (a cross shaped building with a thick spire)
x2 Ponds (a small 2-story building with a long rectangular pool behind it)
x1 Reclining Buddha (normally goes inside the Vihara but you'd have to cut a piece or make the roof detachable)
x1 Sala Kamparien (smaller of the 3 largest buildings, goes on the east side, mirrors the Vihara)
x1 Ubosot (main building and largest, goes in the middle of the 4 cardinal salas)
x1 Vihara (second biggest building, houses the reclining Buddha, goes on the west side, mirroring the Sala Kamparien)
x1 Wall A (surrounds the Vihara, Kamparien, ponds, Monthop, etc)
x1 Wall B (surrounds the Ubosot, cardinal salas, L-salas, etc)
x24 small salas (smallest, generic building that repeats all over the place)

All my things I model myself by hand and brain, please give credit. It's all about spreading culture!

Printing recommendations:

• Use the highest quality possible for better results (0.1mm layer)

• Support Free

• Note: This model has high level of small details, so that when printed in a bigger scale (2:1, 3:1, etc.) or in resin or powder technologies these details are preserved. All details might not be printed correctly in 1:1, FDM.