SonicPad Config for Sidewinder X1 Stock without Macro

After multiple search I could not find the .cfg for a Stock Sidewinder.
So there it is!

Will add Macro I need later here

Guide:
1- Open the Sidewinder from underneath and disconnect the screen. The screen will no longer be used, you can close the printer

2- Start the Sonic Pad and select the "Other" printer all the way to the right of the selection menu.

3- Click on "Motherboard Firmware Compile"

4- In "MCU Frame", select ATMEGA and leave the settings below at their defaults.

5- Click on "Generate" at the top right corner and save the firmware on the provided USB key.

6- Retrieve the .hex file from the USB key and flash the SidewinderX1 with a slicer (or with PrusaSlicer).

7- Download the printer.cfg file from here

8- Turn OFF and reconnect the printer to the Sonic Pad on the port of your choice.

9- Turn ON the printer and click on "Get hardware serial port ID"

9- Modify the first section of the printer.cfg file to match the port indicated by the SonicPad ID given.
"[mcu]
#make sure this reflects your serial port you found when flashing klipper
serial: /dev/serial/by-id/usb_serial_3"

apparently:
usb_serial_1 top left,
usb_serial_2 bottom left,
usb_serial_3 top back,
usb_serial_4 bottom one

and copy the file to the root of the USB key.

10- Connect the key to the Sonic Pad and click on "next step"

The Sonic Pad will read the printer.cfg file and perform connection tests with the printer.

+stand to fix the Sonic pad ;)