Piplup,Prinplup,Empoleon Evolution -FAN ART - POKÉMON FIGURINE -POKEMON

This is "Piplup,Prinplup,EmpoleonEvolution" from Pokémon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Piplup is a light-blue, penguin-like Pokémon, which is covered in thick down to insulate against the cold. It has a dark blue head with a primarily white face and a short, yellow beak. The dark blue feathers on its head extend down its back and around its neck, which causes it to appear to be wearing a cape. There are two white ovals on its chest and a small, light-blue marking resembles a crown above its beak. It has flipper-like arms and yellow feet with three toes each.

Prinplup is a blue, penguin-like Pokémon. It is mostly dark blue with light blue facial markings, wing tips, and lower body. Its eyes are blue and it has a short yellow beak with a small point above it. Two large, yellow ridges extend from its beak over the back of its head and meet just above the nape of its neck. On its body are four large, white spots that resemble buttons. Instead of arms, it has long, sturdy, flipper-like wings that are capable of knocking over and snapping trees. It has short legs with yellow, three-toed feet.

Empoleon is a large, navy-blue, penguin-like Pokémon. It has a wide, yellow beak that extends upward into three pointed horns that form a trident-shaped crest bracketing blue eyes. Large horns are a symbol of leadership and strength for Empoleon. There is a blue marking resembling a crown over its eyes and a white, lacy marking running down its chest. A blue, fin-like projection forms a collar around its throat and runs down the length of its chest and belly. On its back are two raised, gold bumps and a second blue fin that forms its tail. Its yellow feet are webbed with three toes each and its feathers form ruffs above its feet. It has wide, flipper-like wings rimmed with blue along the tips, and three golden claws.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.