AR-15 to Glenfield Model 60 .22lr Stock (Updated V2)

Allows the use of a Ar-15 Stock and Grip to be mounted to a Glenfield Marlin Model 60 - .22lr rifle as a replacement stock.

--UPDATED--
After some time looking over this model I realized the safety on the rifle was slightly obscured by the original stock. V2 now has a cut out that should allow for proper use of the safety now. I have also made a textured version of this model and have added it to the pack.

(Side note: Sorry for not rendering new images to show the changes. My computer is too much of a potato and crashes every time I try. Just making the textured stock took hours to do using solid works 3d texture tool and I was unable to make a textured full stock for the same reason. Thank you for your understanding.)

Tested by printing on a resin printer but should work for FDM as well. This print is vary heavy! Use lots of supports if you print in resin.

(For resin printing) - Place (Part B) so the rifle cutout is facing the bead of the printer at a 45 degree angle and use heavy tree supports with a 80% density. Place (Part A) the same way so the threads and grip mount are at the top of the print. This way the thread pocket will not create a suction effect and ruin the print. All so at a 45 degree angle with heavy tree supports and 80% density.
You will need 4 steel rods as pins to glue side A and B together. Rod size must be 3mm diameter by 60mm long. May need to file down rod by 0.5mm to fit flush if pin holes are not washed well. Use a good Super Glue or other Cyanoacrylate Glue to assemble.