Befletching device / fletching device

Fletching device / fletching device (Ultimaker Cura slicer)

Jerked Is it with PETG pressure settings:

https://youtu.be/jMKhE2BXlj8

A fletching device, or fletching device, is a tool used to attach feathers to arrows in archery. It consists of a holder for the arrow and a device to place the feathers in the correct position on the arrow. The feathers are usually applied to the shaft of the arrow with glue to ensure a stable flight path.

The springs are attached to this design at an angle of 5 ° which has the consequence that the arrow turns slightly in flight and thus gets a more stable trajectory.

Layer thickness: 0.2mm

Temperature: 230°

Printing speed : 50.0

Printing plate adhesion : Yes

Support structure : Yes

A fletching device, also known as a Befiederungsvorrichtung in German, is a tool used for attaching feathers to arrows in archery. It consists of a holder for the arrow and a mechanism for placing the feathers in the correct position on the arrow. The feathers are typically attached to the shaft of the arrow using adhesive to ensure a stable flight path.

The feathers are attached at an angle of 5 degrees using this design, which causes the arrow to spin slightly in flight and thus receive a more stable trajectory.

Layer thickness: 0.2mm

Temperature: 230°C

Printing speed: 50.0

Bed adhesion: Yes

Support structure: Yes.

All parts were printed as you can see in the pictures.

3x Scharben M4 x 25mm screws are still needed.

https://youtu.be/3cSJWT1Tkzs

All parts were printed as shown in the pictures.

Three M4 x 25mm screws are still needed.

Layer thickness: 0.2mm

Temperature: 230°

Printing speed : 50.0

Printing plate adhesion : Yes

Support structure : Yes