Xiaomi Aqara RTCGQ11LM motion sensor compatible tilt and pan wall mount | Xiaomi Aqara RTCGQ11LM motion sensor compatible tilt and pan wall mount

This is a rotation plate compatible for the Xiaomi Aqara RTCGQ11LM motion sensor that allows precise tilting and swivelling of the sensor. The mount replaces the original and by rotation removable battery cover at the bottom. Various wall brackets for M3 countersunk screws, 10x2/10x3 magnets, double-sided tape or a corner bracket with M3 screw can be mounted to the rotation plate, depending on the mounting location. The various wall brackets can be connected to the rotation plate using a piece of 1.75 mm filament. To do this, it is advisable to grip the filament with pliers and insert it with careful pressure of the thumb on the pliers. The friction is quite sufficient to hold everything in place. Alternatively, you can use an M2x12-15 screw.

The rotation plate is designed with minimal gaps, so it may be necessary to separate the frame and rotation plate with your fingernail. To do this, I recommend running your fingernail sideways between the rotation plate and the hinge frame along the full circumference several times until the two separate and the plate can be rotated. If the turntable cannot be loosened, printing in 0.15 mm resolution is an option. In my case, however, the whole thing becomes too loose for my taste.

Just print the parts in STL orientation with 0.2 mm resolution without support. Support may only be useful for the corner piece if there is little adhesion.

Update 21.11.2021: Magnet recess in the magnet holder deeper by 0.6 mm.

------------ I would be very happy if you have as much fun with the things as I do. ------------

If you like :-) Thank you very much!

---- German description ----

This is a rotation plate compatible with the Xiaomi Aqara RTCGQ11LM motion sensor, which allows precise tilting and swiveling of the sensor. The mount replaces the original and by rotation removable battery cover at the bottom. Various wall mounts for M3 countersunk screws, 10x2/10x3 magnets, double sided tape or a corner mount with M3 screw can be mounted to the rotation plate depending on the mounting location. The different wall mounts can be connected to the rotation plate by a piece of 1.75 mm filament. To do this, it is recommended to grab the filament with pliers and insert it with careful pressure of the thumb on the pliers The friction is quite enough to keep everything in place. Alternatively, you can use an M2x12-15 screw.

The rotation plate is designed with minimal clearances, so it may be necessary to separate the frame and rotation plate with your fingernail. To do this, I recommend running your fingernail along the side of the full circumference between the rotation plate and the hinge frame several times until the two separate and the plate can be rotated. If the rotating plate does not separate, printing in 0.15 mm resolution is an option. In my case, however, the whole thing then becomes too loose again for my taste.

Just print the parts in STL orientation with 0.2 mm resolution without support . Only for the corner piece support may be useful if adhesion is low.

Update 21.11.2021: Magnet recess in the magnet holder deeper by 0.6 mm.