Tetra-tower Balance board game!

Fun board game for all ages!

A mix between the classic Tetris and piece balancing games.

It includes several types of difficulty by changing the base and the support, from easy, to extremely difficult, to impossible!!!

Very easy to print! All parts fit in one print!

Includes classic tetris pieces and odd ones that increase the difficulty because of their weight.

Please pay close attention to the printing parameters.

If you like the design, please like it. If you have any suggestions, don't hesitate to comment. And if you want more designs like this, follow me!

The game is that the base should be unstable, so it should be as light as possible.

3 lower and 4 upper layers

7% grid type filler to make the top layer printable yet lightweight.

2 or 3 perimeters maximum.

In my case I printed everything in off-white PLA and then painted the pieces with acrylic paint, which caused them not to slide easily. It didn't make it impossible to play, but I recommend, if you want colorful pieces, to print them with different filaments.

the combination that works best is the regular base with the easy stand. The very easy base practically does not fall off (recommended for small children or those with little patience). The difficult base makes it more unstable, but if combined with the difficult stand it is practically impossible to put pieces on top of it without it falling over.