Graph Caddie Lite Accessories

An accessory pack for the Graph Caddie Lite shuttle.

Accessory Kit Includes:
- Utility Bar
- Rod Holder
- Bait-Beverage Holder
- Ice Defense Holder
- Standard Cable Tab
- XL Cable Tab
- Transducer Arm
- Glow Cup (3 piece - Top,Middle,Bottom)

Hardware
- 20 - #4- 3/8" or #6-3/8" Wood Screws for accessories
- 6 M3 x 20mm screws (For Glow Cup)
- ~ 2.5"x2.5"x.125"T (or 2.5" Dia) Clear Acrylic (For Glow Cup)
- 4" or 6" UV LED Light Strip with adhesive backing (For Glow Cup)

Glow Cup
The glow cup prints in 3 pieces.
Once printed, do the following:
1. Line middle ring up with bottom piece. Trace a ring on the bottom piece around the inside of the middle ring .
2. Drill a ~1/8" hole in the bottom piece close to the attachment point. Make sure to be near the trace line but not underneath where the bottom and middle would attach together.
3. Run LED Strip wire through hole.
4.Remove the adhesive backing from the LED strip and apply it to the inside diameter of the middle ring.
5. Place the 2.5" dia. clear acrylic puck between the middle and top section.
6. Run screws through all three pieces and tighten them.

Digital files have a strict non-commercial, personal use only license. You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used in any way whatsoever in which you charge money, collect fees, or receive any form of remuneration.

Links to Amazon Products are part of the Amazon Affiliate Link program.

• 0.2mm Layer Height
• 50% Infill (Max)
• 10hrs to print all with Bambu Labs X1C (~40 hrs with Ender 5 Pro)