Pit Boss Pro Series Pellet Chute

This Pellet Chute is a modified version of my original pellet chute for Pit Boss Pellet smokers.
The new version is wider and has a recessed section of flange to allow clearance for the power cable exiting the rear of the pellet hopper.
and has a 3" wide opening.
I have attached a picture of the port opening, for this to work there should be no screws or protrusions around the port, which can be found on some models. many styles share this same port design.

The Chute is attached by embedded magnets which are installed using a pause print G code. 12 required
magnets used-
https://a.co/d/64gm0yA

For Personal Use Only
Upon Payment you are agreeing to not distribute, and or use this product or derivatives for financial gain.

These are just my settings, other settings can be used.
PLA+ or better,
215/60
60mm/sec
.6mm nozzle at .28 layer height
20% infill
No supports needed
requires 12 magnets which are installed using a pause print G code somewhere around layer 22 depending on your layer height, and a dab of super glue just to hold the magnets in place.

I would suggest if you have a CR touch or ABL With metal probe, to put a small piece of tape over the probe when the print pauses because the magnet may draw out the probe and cause a collision, ask me how I know....
Filament used-
Sunlu Pla Plus, 220*C first layer 215*C nozzle/60*C bed
Usually prints in 7 hours