Painting handle V2.0 (more stable with weight)

Iron weight in center of gravity for heavier or larger minis!
Innovations:
- More stable with iron weight in inner space.
- Higher rim on clamps
- Narrow rim on disk

Print one holder, one holder buttom and two clamps. All of parts NOT need support. Need two rubber ring to assembly ~ø20mm and iron weight in inner space (ø32x30mm). I using screw washer but can be you use sand or others weight tings. The bottom cover is threadedly connected to the handle. You can control the size of the internal weight at any time.

The closed clamp distance at the rubber mount is 40mm.
The size of clamp inner ring is 20mm the outer is 30mm. Maximum clamping size is ~55mm.
Made two disks ø40mm and ø50mm if your models have not base. Thus you can using plasticine for model mounting.

Rafts: No
Supports: No
Resolution: 0,2
Infill: 50
Filament any PLA

When you printing put the parts close to each other and add brim, this will stable when printing.
I printed 3 wall lines and 50% infill but less is enough. (I wanted it to be a heavy weight, it will stable when painting the models if I'll put it on the table)
After the print you need to smooth the surfaces and edges of holder slider with fine sandpaper.
Optional: I printed with Cura and I click on the Fuzzy skin on outer side except for sliding parts (I added a modifier cube for parts - can You see on pictures)