Mega Tyranitar - FAN ART - POKÉMON FIGURINE -POKEMON

This is "Mega Tyranitar " from Pokemon series
I will be releasing my work on daily basis, some may even be free! so please follow and keep your eye on my updates !!cheers

PLEASE CHECK THEM OUT(OTHER 3D MODELS FROM THE SAME DESIGNER)!

Tyranitar is a large, bipedal, dinosaurian Pokémon with a green, armor-like hide covering its body. It has two pairs of pointed teeth: one in the upper jaw and one in the lower. Several spikes of varying size protrude from the back of its head, neck, and shoulders. Both sides of its chest, the center of its back, and its knees have two triangular holes. There is a gray, diamond-shaped patch of scales covering its belly, and a smaller one on its back. It has three claws on its feet and hands. A ring of spikes surrounds the tip of its tail.

Mega Tyranitar has more gaps in its armor than its normal form, with four new triangular holes along the sides of its neck and one on its throat. The four holes on its chest are now larger with the top two containing red ovals. While the spikes along the back of its neck grow shorter, the ones on its head elongate to form prominent ridges along its brows. The center spike on its head becomes a long, upright horn. Its chest plate expands, curving over its shoulders and along its back to form three long, irregular spikes on each side of its body. The scales on Mega Tyranitar's belly have now become red instead of blue and seethe with energy, enabling it to emanate more power.[1] It gains two sharp spikes on its knees, as well as more prominent leg joints. Its tail lengthens, with the three spikes surrounding its tip growing upward and outward. Its back had split open because of the overwhelming power from Mega Evolution.

*This model require minor support to print with FDM .
*to have a better print result I would suggest to print this model in angle where the front surface facing upwards to avoid support structure in FDM prints, for DLP & SLA should be fine.