One Night Ultimate Werewolf + Expansions boardgame insert with passive speaker

NOTE: It is important that you print this with NO SUPPORTS, since I expect they will be impossible to remove from the speaker cone. The model comes pre-built with adequate permanent supports.

This is actually from-scratch, but the measurements were shamelessly stolen from Kabong's design! (thanks Kabong, I don't actually own the expansions, so this was very helpful)

The box is, by default, too big for these game pieces, even with all the expansions, so I was originally planning on printing Fier_Prints's minimalist design.

However, after I noticed that the cards would fit vertically side-by-side, I wondered: can I make use of the extra space?

When I play this game, I use the phone-app to do the narration, but often times it is too quiet (depending on the phone speakers' quality) to properly cover up all the card movements and shifting around the players do during the night phase.

So I used the extra space to add a passive speaker cone to the insert! (why not)
This way, the phone-app-narration can be extra loud. My quick test showed an increase of around 5dB, so just over 3x the volume! (nice)

Like Kabong's design, this is made to fit in the standard box, and has one slot for the base cards, and another for the expansion cards. It also has three distinct slots for the tokens: base game character tokens, expansion character tokens, and artifact tokens.