fishing bite alarm

I recommend you also take a look at
NEW : PRACTICAL FEEDERS (3 types 9 variants )

https://cults3d.com/:1906687

my boilise press

https://cults3d.com/:814867

Hello fishermen . These are two sizes of hangers (206mm and 285mm) that are printed in one piece, but can be separated into parts in the slicer. You can print on a diagonal of 45 degrees . Includes a protective cover that fits 1 large and one small bite alarm. The silon end is tightened with a rubber band and only clicks on the end of the bite alarm. The couplings are printed separately. Each bite alarm has a total of 3 joints . Push the clutches with force and they don't even need glue . The movement is maximally flexible because the bite alarm has large backlash

I made two more ones for fastening to the zip tie. They are shorter, but otherwise have the same size as with holes

holes for rod holder holes are two versions 5.1 mm and 6.3 mm .The rod holder holes are two versions 5.1 mm and 6.3 mm. Measure the diameter of the rod . In my case, it has 4.7mm, so it is advisable to use a model that has a 5.1 mm hole

Screw, use M5 or just about anything that fits into that hole :P

All my fishing equipment

https://cults3d.com/en/design-collections/BIONICFACTORY/fishing-equipment

Use exclusively PETG material . In slicer sets on hangers 50 wall , 0 top layer , 0 bottom layer ! It is necessary to print in such a way that maximum flexibility and strength are achieved

                ---- Printing setup for   hangers----  

In slicer set 50 wall
0 top layer
0 bottom layer
100% infill
0,3 mm layer heigh
petg temperature 235 / 80

No support

        -----Setup for box  ! ---

3 top layer
3 bototom layer
2 walls
30 % infill
0,3 mm layer height
No support