Geared Heart Version 2

A redesign of this thing http://www.thingiverse.com/thing:253934, Geared Heart Version 2 is a simpler mechanical design and uses the dual color extrusion capabilities of the Ultimaker 3.

The dual color base consists of two components; "Base.stl" and "Gear Heart Bottom.stl", that are joined together using Cura in order to allow for dual extrusion. And as was in the original design, you'll need to download, print and assemble Emmet's 2-3 gears onto "Heart Center.stl" as per the original design instructions.

Video of prototype is here: https://www.youtube.com/watch?v=cwbgl-woX0U.

Designed using Fusion 360, sliced using Cura, and printed on an Ultimaker 3 Extended.

Printer Brand:

Ultimaker

Printer:

Ultimaker 3

Rafts:

No

Supports:

No

Resolution:

.1mm

Infill:

50%

Notes:
To assemble the dual color base, I used Cura 2.3.1. The "automatic" model merge would not correctly merge "Base.stl" and "Gear Heart Bottom.stl", so I turned off "Ensure models are kept apart" and "Automatically drop models to the build plate" features on the Cura "Preferences, General" pane. Next, , I loaded "Base.stl" then "Gear Heart Bottom.stl" onto the build plate, then raised "Gear Heart Bottom.stl" 22mm (z axis), and 1.25mm right (x axis), thus my offsets were x = 1.25, y = 0, and Z = 22.

Post-Printing
After printing, test fit "Heart Center.stl" in "Knob.stl". Once tested, slide "Heart Center.stl" into the base assembly, then press "Knob.stl" onto "Heart Center.stl.

Finally, add the pins and gears to "Heart Center.stl", making sure each gear rotates on it's pin smoothly before proceeding to the next.

Hope you like it!

Remixed From

Geared Heart, Hand Crank Edition
by gzumwalt