Spool Holder for 3D Printing Nerd Design Challenge
Spool Holder for 3D Printing Nerd Design Challenge
3D
Published 2018-08-21T17:07:02+00:00
Hey everyone,
this is my solution for Joel´s problem.
The brackets are fits over the wooden planks and can be fixed with screws (max. 3mm diameter).
For one spool you will need:
- 1 Bracket L
- 1 Bracket R
- 1 Clip L
- 1 Clip R
- 4 Bearings (608)
- 1 Filament Bracket
You can also make an endless row you just need to add Bracket M, Clip L & R like you can see it in the pictures.
The Filament Bracket can also be fixed with a screw. It´s job is to lead the filament so that you can print whereever you want. The filament will be always guided directly from the spool to the bracket and from there to your printer. If you don´t use one of the spools you can clamp the end of the filament in the Filament Bracket, too.
I hope you enjoy my solution
- No support needed
- Designed for a high infill (75-100%)
| Date published | 21/08/2018 |
| Support Free | YES |