TS100 Soldering Iron Holder Station

I want a more heat resistant holder for my TS100 soldering iron and had the idea, to do it with a 608ZZ ball bearing.

You need these items:

• Best: 608ZZ full metal https://goo.gl/FBvJlY or full ceramic https://goo.gl/zOZmrN ball bearing. 608-2RS with plastic caps and plastic spacer may also work, but it could melt.
• M3 screw 12mm or longer
• M3 spring or normal washer
• M3 nut
• Best: 45mm x 55mm soldering sponge https://goo.gl/gwxxUH in wet state. You can also use these ones https://goo.gl/X6Ntuh and cut it to the right size, while it is wet. Maybe these already has the right size.
• Masking Tape https://goo.gl/Rjt3k4

How to support me?
Do you like my things and do you want to support me? You can use these links if you want to buy something. This helps me doing more things. Thanks!

Banggood: https://goo.gl/ZXgx3A
Gearbest: https://goo.gl/FfE59f
Aliexpress: https://goo.gl/bQLi15

Rafts:
Doesn't Matter

Supports:
Doesn't Matter

Resolution:
1/2 of nozzle diameter. E.g. 0.2mm layer height with 0.4mm nozzle

Infill:
30%+

Notes:
No support is needed for this thing.

Step 1: Wrap one or two layers of masking tape around the ball bearing. This is for heat isolation and is also needed to tight fit the bearing into the shell.

Step 2: Put the ball bearing into to holder and put the bearing holder on the top of the soldering station base. After that, put the screw through the holes.

Step 3: Put the washer and nut on the other side and tight it with a wrench and a screwdriver. The angle between the holder and the station is fixed.

Step 4: Moistening the soldering sponge and put it in the shell.