logo made in France, Made In France logo

Reproduction close to the official logo visible on the government website to promote the "made in France.

Consists of 4 main parts, connecting pins and letters.

You will need to add a cord to connect the card to the panel. Holes are provided to accommodate the cord and a top hole is provided for a possible suspension hook. If you want to put it down there is a two-part foot included in the files.

I advise you to print the visible side on the tray, if you have a mirror it will give a smooth and glossy appearance. Be careful to avoid peeling off in this case especially on the blue part.

The three pieces of the card are assembled with the 4 pins provided for this purpose, without glue so as not to risk burrs at the joint lines if necessary, only put glue in the bottom of the holes receiving the pins.

The panel receives letters that can receive a glue point to ensure. Also print face up against the mirror using a holder for the hollow of the letters. The counters for the panel are to be glued on the panel, and in the holes in the central part of the card.

A foot allows you to place the card, prefer a white print because it supports the card in its white part. It is in two parts with glue assembly and 2 wood screws of 3 x 12 mm.

If you want to promote production in France in your company, your workshop you can use this print for your trade fairs or your reception desk.

Printed on a CR10 stock on a Leroy Merlin mirror without glue. Mirror at 60°C filament at 230°C, speed 45 mm/s in ArianePLAST PLA for the blue, red and grey letters and a snow white PLA for the white part.

Use 30% filling and 5 top and bottom layers. 0.2 mm layers.