Airsoft Magazine Racks (M4, G3, VSS, and SR25)

These are a set of racks I designed for storing various airsoft gun magazines. As I make more for different platforms I will update this post.

Let me know how they work for you! Happy printing!

The "M4 Mag Rack.stl" is designed to work with all standard width M4 airsoft magazines. (It is very possible that there are some types/sizes that will not fit see the list of known working ones below)

The "M4 Mag Rack.stl" has tested to work with
- ICS TMAG's
- Evike.com BAMF Polymer Mid-Cap Magazines
- Lonex Full Metal M4 Flash Magazines
- The short A&K 70rd Mid-Cap Magazine

The "VSS Mag Rack.stl" was designed for and tested to work with both the short and long LCT VSS Vintorez magazines, your milage may vary with other brands.

The "G3 Mag Rack.stl" was designed for and tested to work with the LCT G3 magazines.

The "VSS Mag Rack.stl" was designed for and tested to work with the G&G SR25 mag (120 round) & A&K stamped steel type SR25 magazines.

For mounting the Magazine rack I used some #8 Flat head screws I found at my local hardware/ home improvement store. I used 1/2" long since the cabinet I was mounting it too was relatively thin however longer should work just fine too. (#6 will probably work in a pinch)

You will probably find them cheaper locally but here is an example of the type of screws.
https://www.amazon.com/gp/product/B01LDVHCDW/ref=crt_ewc_title_huc_1?ie=UTF8&psc=1&smid=A2GM3D5OCSHPC3

Alternatively double sided foam tape or 3M Command Strips could be used instead of the screws.

Rafts:
Doesn't Matter

Supports:
No
If your printer can handle 20-30mm bridges you should be able to print this with no supports in the Upside down orientation (see the picture), otherwise it will work fine with supports too.

Resolution:
0.2mm

Infill:
20%